Craftsman of 19.2 volt battery-battery tools include drills, circular saws and hand vacuum cleaner. A battery replacement, which do not become a burden can often it costs about 30 percent of a new tool. To save money, try fastening of the battery. 16-The nickel-cadmium or NiCd batteries can lose their ability to hold a charge over the course of time. Enter the battery an impulse load break tiny crystals in the cells, so that they more energy to keep and maintain the charged battery longer.
Read the label on your Craftsman 19.2 volt battery and make sure that it contains NiCad cells. If it contains the Li Li-ion or Li - on cells, try not to repair the battery, Li-on because the batteries a circuit breaker which receives the amount of the fee a cell limit. Overload circuit breaker can cause, Li batteries catch fire or explode. If your battery Li problem on cells, a new purchase.
Put glasses gloves, rubber, small, easily. You must produce three sons 12 volt batteries in a row, that required 36 Volt, reload your 19.2 Volt pulse. During 36 Volt gives you a dangerous electric shock, do not, you will feel a tingling sensation, if the mobile device contact with bare hands. Charge pulse produced also a spark, so that you want, keep your eyes protected.
At the end of the cable from the positive pole of the battery of 12 volt battery, set the clip spring. Plug the other end of the cable to the negative terminal of the second battery.
Attach one end of a battery cable positive pole and the other end seconds at the second battery to the negative terminal of a battery by a third party.
Attach the cable to negative pole of the battery of the battery one-third. Connect the cable from the battery fourth to three battery positive pole. Make sure that the two sons do not touch other.
Plug the other end of the cable to the negative terminal of the battery to the negative terminal of the battery of your craftsmen 19.2 Volt.
Touch the other end of the cable to the positive pole of the battery to the positive pole of the craftsman battery. To reach you quickly you post the cable on the 10-15 times in 5 seconds. This leads to a load of heart rate, that breaks the crystals. You'll see a spark when you to touch the Terminal.
Aside craftsman battery for 10 minutes after you have loaded impulse. Then he loads charger for 20 minutes with your normal craftsmen.
Check the voltage of the battery of your craftsmen with a voltmeter produced. Imagine the Red or positive, the cable of the meter with the positive pole of the battery. You get black or negative cable to the negative terminal. The voltmeter should save between 18.5 and 19.2 Volt. Remove the cable from the battery, and write the reading. Insert the battery side for 1-2 hours, to see whether it commissioned one person.
The voltmeter, attach the wires to the battery as before. If the measured value is 0.5 volts at first reading, the battery attached. If the second reading is greater than 0.5 volt less than the first reading, repeat to load pulse. He is step improvements not ya after an impulse to load from 10 to 15 times, you need a new battery.